Configure a Dell switch to send logs to Arctic Wolf using the CLI

You can configure Dell switch® to send the necessary logs to Arctic Wolf®.

Note:

This is an optional configuration. Discuss this log forwarding option with your Concierge Security® Team (CST).

These resources are required:

Launch your SSH client

Connect one end of your modem cable to the CONSOLE port on the Dell switch.
Connect the other end of your modem cable to a serial port on the configuring computer.
In your SSH client, configure these settings:
- Serial line — Enter COM1.
- Speed (baud) — Enter 115200.
- Data bits — Enter 8.
- Stop bits — Enter 1.
- Parity — Select None.
- Flow control — Select None.
Sign in to the CLI with administrator permissions using your SSH client.
Run this command:
BASH
configure
```
configure
```
Run this command:
BASH
logging <ip_address>
```
logging <ip_address>
```
Where:
- ip_address is the IP address of your Arctic Wolf physical or virtual sensor.

Sign in to the Portail unifié Arctic Wolf.
In the navigation menu, click Tickets & Alerts > All Tickets.
Perform the appropriate action, depending on if you are:
- A new customer — In the Ticket Type list, select Onboarding. Then, click the existing [Deploy] Site Config: <ticket_subject> ticket.
- An existing customer — Click Open a New Ticket.
On the Open a New Ticket page, configure these settings:
- What is this ticket related to? — Select General request.
- Subject — Enter Syslog changes.
- Related ticket (optional) — Keep empty.
- Message — Enter this information for your Concierge Security® Team (CST):
  - Confirmation that you completed the steps in this configuration guide.
  - The IP address or hostname of the Capteur Arctic Wolf that you used during the configuration.
  - The IP address, timezone, and device type for all sources that you are forwarding.
  - Questions or comments that you have.
Click Send Message.

Your CST reviews the details to make sure that Arctic Wolf is successfully processing the logs.